diff --git a/modules/ROOT/pages/_partials/proc_changing-to-enforcing-mode.adoc b/modules/ROOT/pages/_partials/proc_changing-to-enforcing-mode.adoc
index 659b4da..59a564a 100644
--- a/modules/ROOT/pages/_partials/proc_changing-to-enforcing-mode.adoc
+++ b/modules/ROOT/pages/_partials/proc_changing-to-enforcing-mode.adoc
@@ -7,13 +7,7 @@
 
 When SELinux is running in enforcing mode, it enforces the SELinux policy and denies access based on SELinux policy rules. In Fedora, enforcing mode is enabled by default when the system was initially installed with SELinux.
 
-If SELinux was disabled, follow the procedure below to change mode to enforcing again:
-
-This procedure assumes that the [package]*selinux-policy-targeted*, [package]*selinux-policy*, [package]*libselinux*, [package]*libselinux-python*, [package]*libselinux-utils*, [package]*policycoreutils*, and [package]*policycoreutils-python* packages are installed. To verify that the packages are installed, use the following command:
-[subs="quotes"]
-----
-~]$ rpm -q _package_name_
-----
+First check the current SELinux mode by running the [command]`getenforce` command. If it displays `Disabled`, then follow <<{context}-enabling-selinux>>. Otherwise, if it displays `Permissive`, follow the procedure below to change mode to enforcing again:
 
 . Edit the `/etc/selinux/config` file as follows:
 +
diff --git a/modules/ROOT/pages/_partials/proc_enabling-selinux.adoc b/modules/ROOT/pages/_partials/proc_enabling-selinux.adoc
index b6c267e..1abea3d 100644
--- a/modules/ROOT/pages/_partials/proc_enabling-selinux.adoc
+++ b/modules/ROOT/pages/_partials/proc_enabling-selinux.adoc
@@ -9,6 +9,12 @@ When enabled, SELinux can run in one of two modes: enforcing or permissive. The
 
 While enabling SELinux on systems that previously had it disabled, to avoid problems, such as systems unable to boot or process failures, follow this procedure:
 
+This procedure assumes that the [package]*selinux-policy-targeted*, [package]*selinux-policy*, [package]*libselinux-utils*, and [package]*grubby* packages are installed. To verify that the packages are installed, use the following command:
+[subs="quotes"]
+----
+~]$ rpm -q _package_name_
+----
+
 . In case your system has SELinux disabled at the kernel level (this is the recommended way, see <<{context}-disabling-selinux>>), make sure to undo that first.
 
 .. Check if you have `selinux=0` in your kernel command line:
@@ -27,6 +33,12 @@ _[...]_ rd.lvm.lv=fedora/swap rhgb quiet *selinux=0*
 
 .. The change will be applied after you reboot the system (see below).
 
+. Ensure the filesystem is relabeled on next boot:
++
+----
+~]# fixfiles onboot
+----
+
 . Enable SELinux in permissive mode. For more information, see <<{context}-changing-to-permissive-mode>>.
 
 . Reboot your system.